FUNCTIONALITY
1. SRP-22 roller blind controller can be simultaneously controlled by:
a. EXTA LIFE system transmitters / IN1, IN2 external inputs
• local control mode,
• central control mode,
• activation up to two favourite settings,
• in case of external inputs, control by means of single and double push-buttons,
b. the EXTA LIFE mobile application after pairing with a controller,
• close / open / stop type of control by means of control push-buttons,
• % adjustment of roller blind closing position by means of a slide,
• activation of 4 favourite settings maximum.
2. Current roller blind position is shown in the mobile application (% of c icon). The icon
indicates only 3 modes: fully opened roller blind, fully closed roller blind, half opened roller blind.
3. It is possible to assign a larger number of push-buttons of EXTA LIFE radio transmitters to one
controller – maximum 96 pairs (e.g. 24 transmitters in a local mode).
4. Transmitters’ push-buttons can be assigned to the SRP-22 controller by means of the PROG.
push-button, or „remotely” by means of the mobile application (without a direct access to a dim-
mer).
5. Few SRP-22 controllers can cooperate with one transmitter – it enables to group roller blinds
(central mode is recommended in this situation) or to control a roller blind independently from
different places.
6. A roller blind controller can be paired only with one EXTA LIFE controller (after pairing, it is not
visible for other controllers).
7. Push-buttons added to SRP-22 can be selectively deleted.
8. There is a possibility to delete simultaneously all push-buttons added to a controller’s memory
(reset to default settings).
9. Basic SRP-22 parameters are configured by means of the mobile application.
10. A remote software update of a controller is also possible due to the mobile application (the EXTA
LIFE controller must be connected to the Internet).
3. It is recommended that the position of a roller blind connected to a controller during instal-
lation and programming is in its minimum or maximum position (completely open or closed).
Otherwise, just after programming the remote control or pairing the drive with the controller,
it is necessary to force the movement of a roller blind to adjust its position to the minimum or
maximum (up or down).
4. It is possible to connect debouncing roller blind push-buttons to IN1 and IN2 inputs in a wired
way of control. By default, the controller cooperates with double debouncing roller blind push-
buttons. To connect a single push-button, it is necessary to short-circuit IN1 and IN2 inputs or to
adjust “Single roller blind push-button” by means of a mobile application as an input type (then
it is possible to connect the push-button to the IN1 or IN2 input).
5. During mounting, make sure the receiver is not exposed to direct water and operation in an
increased humidity environment. The mounting ambient temperature range should be within
the range from -10 to + 55 °C.
6. The SRP-22 controller is designed to be mounted indoor. In case the controller is mounted
outdoor, it must be placed in an additional hermetic casing.
7. After the SRP-22 receiver has been installed, it is important to check if it operates correctly. In
case of control by means of the EXTA LIFE system transmitters, they must be first programmed
with a receiver (see Programming transmitters). In case of cooperation with a controller, a
correct pairing of a receiver with a controller is required (see Register of receivers in the EXTA
LIFE system). Local inputs in the default setting mode are ready to operate at once.
