REGISTRATION (PAIRING) ROP-21 IN THE EXTA LIFE SYSTEM
DELETING (UNPAIRING) ROP-21 FROM EXTA LFE SYSTEM
In order to register ROP-21 in the system, it is necessary to connect the EXTA LIFE controller in
the system and to install the EXTA LIFE mobile application. The receivers must be connected to
230 V AC. They are remembered in the system only after they have been properly paired with a
controller. To do it carry out the following steps:
1. Activate the application and enter the Device screen.
2. Choose the receiver tab and press „+” (
) to start the searching process of receivers installed
in the system. It lasts no longer than 60 seconds and can be stopped by means of the „Stop”
push-button. All receivers located within the controller are automatically displayed in a list
form with a default name including the receiver’s name (ROP-21) + 6- digit ID serial number
assigned to this receiver (
).
3. After searching has been completed (
), press the ‘TEST’ button to quickly locate the receiver
(the receiver’s output is switched on as long as the TEST push-button is pressed).
4. By marking fields next to the ‘TEST’ push-button, (
) we choose receivers to be paired with
the EXTA LIFE controller. It is possible to mark more than one receiver.
5. Press the ‘PAIR’ push-button to pair the marked receivers. After a while the receivers are
registered in the system and are visible on the list in the Receivers tab (
).
6. After pairing, a default icon is assigned to the ROP-21 receiver.
7. The receivers, just after pairing, can be controlled at once by means of application buttons.
The receiver’s mode is signalled by a switch position and a switch icon (
). By default, control
is carried out in the switch on / switch of mode. If in the configuration tab the ‘switch on time’
parameter is set, then a receiver starts operation in time mode with the defined time. Time is
adjusted in the range from 1 sec. to 18 hrs.
8. The receivers can be paired individually – press the “PAIR” push-button and assign a new
name to a receiver. In case a larger number of receivers are paired, they are automatically
saved with default names.
9. After pairing, it is possible to add an individual name and icon (from the icon base) to each
ROP-21 receiver.
10. Only after pairing the receivers can be used in the system in a further configuration process
(assigning a user, a category, building scenes, time and logic functions).
Each registered ROP-21 receiver can be deleted from the system. Deleting means ‘unpairing’ a
receiver from a controller.
In order to delete a receiver from the EXTA LIFE system, the following steps must be carried out:
1. Activate the application and enter the Device screen.
2. Select the receivers tab, next select the “Delete” option from a particular receiver’s menu.
3. After deletion, a receiver is automatically removed from the list of paired receivers.
CAUTION: In order to register receivers successfully in the system (mainly if there is a
larger number of receivers), it is necessary to activate the device pairing method several
times and pair the ones that were found.
