ZAGI ZAGI-DC, Инструкция по сборке

Страница: 3 / 19

The Zagi-5C Kit Contents:
2 Expanded polypropylene (EPP) wing panels and beds
2 Pre-cut airfoil shaped balsa elevons
5 .03 X .31 X 24 Carbon fiber spars
1 Roll 2.2 mil color poly tape
2 Control horns with 2 screw plates and 4 screws
2 Threaded 2-56 control rods
2 Threaded 2-56 clevises
2 Die-cut clear plastic winglets
1 EPP foam block for repair and reinforcement
1 Roll of 2” wide fiber filament tape
1 2” x 5.5” Styrene electronics bay floor
Needed Components:
1 Receiver (RX)
2 Standard servos (cutouts are for “standard” servos but minis may be used)
1 Battery A 600 mAh Nicad AA size battery will allow several hours of flying
before recharging.
Tools and Materials Needed:
Small 90 degree square
Sanding block
#150 to #320 grit sandpaper
X-acto knife with #11 blade
Dremel (optional)
Spray adhesive (3M Super 77)
Lead weights for balancing (if needed)
Additional roll 2.2 mil color poly tape in contrasting color (optional) - see text
Round pencil or ball point pen
Mixing (popsicle) sticks
Clear food wrap
Scissors
Z-bend pliers (optional)
3