ZAGI ZAGI-DC, Инструкция по сборке

Страница: 11 / 19

Fold the tape around the tip and cut it to the contour of the bottom
surface. Trim and fold the tape into the battery, servo and receiver
bays.
Cover and trim the top left wing panel. Repeat the same taping
procedure as on the right panel.
Cut out the electronics bay floor. Lay the part on a piece of
newspaper. Spray the part with adhesive. Center the floor over
the electronics bay and press it in place.
Spray a mist coat of adhesive to the bottom side of the part.
Apply two strips of fiber tape cordwise (parallel to the center line)
over the part.
Spray another mist coat of adhesive on all bottom surfaces of the
wing including the areas covered with fiber tape. Complete the
color tape covering on the bottom of the wing.
When the entire top and bottom are covered, wrap a spanwise
strip of color tape around the leading edge.
11