ZAGI ZAGI-DC, Инструкция по сборке

Страница: 12 / 19

Position the elevon against the TE. Position a straight-edge
parallel to the center line at the inboard edge of the servo bay.
Make a cut line on the elevon. Position the straight-edge to match
the angle of the wing tip. Make a cut line on the elevon to match
the wing tip. Trim the ends off the elevons at the cut lines.
Sand a 45 degree angle into the front of the elevon. Sand the
elevons and smooth all the surfaces.
Spray the elevons with a mist coat of adhesive. Apply color tape
to cover the entire surface.
Position the elevon on the trailing edge of the wing. Align a
straight-edge with the wing tip. Leave a 1/16” space between the
end of the elevon and the straight-edge. Use small pieces of
masking tape to hold the elevon in position temporarily. Best to
leave a corner of the tape turned up for easy removal.
Color tape may be used to make a hinge. Holding the end of the
tape over the seam press the color tape in place while peeling it
back. Remove the small pieces of masking tape ahead of the
color tape. Press the tape down along the length of the elevon
with a squeegee.
Press the servos in place with the control arms centered at 90
degrees to the servo case. The servo case should be flush with
the surface of the wing and the control arms sticking straight up
above the wing surface.
12