DOC-USR-0038-05
_______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
31
Gop Size
15, 30,
60
, 120, 240
I-frame frequency. A GOP size of 15, for
example, would mean 1 I-frame every 15
frames.
Video Burst Size
150 – 2000ms (
300
)
# of ms to buffer. The higher the value, the
smoother the encode, but also the higher
the latency.
Video Codec
H.264
, MPEG-2
The codec to use for video encoding.
Frame Decimation
None
, 1/2, 1/3, 1/4
Used to reduce the frame rate. For
example, selecting “1/2” frame decimation
for 30fps input would cause a bitstream to
be encoded at 15fps.
Output Interface
Ethernet (VBR)
ASI
ASI+Ethernet (CBR)
Selects where bitstream is output
(Ethernet, ASI, or both). Note: RTP can
only be streamed over Ethernet.
Output Format
RTP
MPEG-2 TS
MPEG-2 TS RTP
RTMP
Output format of encoded stream. Note:
RTP requires an SDP file for the receiver.
“MPEG-2 TS RTP” sends a stream
encapsulated with MPEG-2 TS within an RTP
transport stream.
For more on using “RTMP”, please see the
section on RTMP.
Dest Address
w.x.y.z
(225.1.2.3)
The IP address that the encoder is
streaming to.
Dest Port
0 – 9999 (
8888
)
The port that the encoder is streaming to.
TS Bit rate
0 – 20Mbps (
12Mbps
)
Only appears for “MPEG-2 TS” and “MPEG-2
TS RTP” Output Formats. The overall bit
rate for the generated transport stream. A
margin of 30-50% over the video bit rate for
high bit rates is recommended.
PID Audio, Video,
PCR
0 – 999 (
120, 220, 520
)
The PIDs assigned to audio, video, and the
PCR in the TS stream. Values are separated
by a space.
Local IP Address
192.168.X.XX (
192.168.0.65
or 192.168.0.66
)
Sets the IP address of the Z3-MVE-02.
Disregarded if “Use DHCP” is checked.
Local Netmask
255.255.X.X (
255.255.0.0
)
Sets the netmask of the Z3-MVE-02.
Disregarded if “Use DHCP” is checked.
Default Gateway
192.168.X.XX (
192.168.0.1
) Can generally leave as “192.168.0.1” --
disregarded if “Use DHCP” is checked.
Use DHCP
[Checkbox]
On /
Off
On -> Use DHCP to get IP address at boot-up
(see “Using DHCP”).
