PDQXDOV]ZDYHHXURSHFRPPDNHSKS"ODQJ HQ W\SH VNX =0(B5&
KWWSPDQXDOV]ZDYHHXURSHFRPPDNHSKS"ODQJ HQ W\SH VNX =0(B5&
Product description
The Z-Wave.Me Remote controls Z-Wave actuators such as dimmers, switches, thermostats or motor controls
for blinds or jalousies and it can activate scenes in central gateways or any other Z-Wave devices. Devices can
be turned on and off but dimmers and motor controls can also be turned into a desired dimming level to motor
position by keeping a button pushed and releasing it. Although it is controlling other devices, the device can
not act as Z-Wave network controller (primary or secondary) and will always need a Z-Wave network controller
to be included into a Z-Wave network. The device can be used in different modes that are selected by
configuration parameters 11-21:
1. Direct control of associated devices
2. Control of all devices in the Z-Wave network
3. Simple and enhanced scene activation
10 pair of buttons - illuminated by blue light when operated - allow to control up to 10 control groups (either
association groups or scenes)
Batteries
The unit is operated by batteries. Use only batteries of correct type. Never mix old and new batteries in the
same device. Used batteries contain hazardous substances and should not be disposed of with household
waste!
Battery Type: 4 * AAA
Behavior within the Z-Wave network
I
On factory default the device does not belong to any Z-Wave network. The device needs to join an
existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the primary
controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion mode.
Please refer to your primary controllers manual on how to turn your controller into inclusion or exclusion
mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave the
network. Leaving the network - i.e. being excluded - sets the device back to factory default.
If the device already belongs to a network, follow the exclusion process before including it in your network.
Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to
be reset first.
For including/excluding the remote control into an existing the Z-Wave network do the following steps:
Bring your primary controller into inclusion mode.
For Inclusion press the "Inclusion" button 3 times. The LED will flash green for a moment for
confirmation.
For Exclusion press the "Exclusion" button for 5 secs. The LED will flash green for a moment for
confirmation.
Operating the device
