Z Microsystems StarGate 20, Руководство пользователя

Страница: 8 / 64

Doc# 27-0027UM Rev 1.0 Issued 10/04
8
It is important to use the
proper screws.
To secure the StarGate to
the frame, use four Pan-
head Phillips screws and
washers on each side, for
a total of eight.
NOTE: All four screw
holes in the
RETMA rail
must be visible
through the
four screw holes
on both sides of
the StarGate.
If not, move the
StarGate up or
down until all
four holes are
visible.
NOTE: Installing the
StarGate
requires two
people, one to
hold the unit,
while the other
secures the unit
with screws.
One person hold the right
side of the StarGate, while
the other person secures
the fi rst screw in the upper
left corner of the unit.
Before inserting any
additional screws, check to
see that all the remaining
seven holes in the
StarGate line up with the
screw holes in the RETMA
rails.
Then secure the remaining
seven screws. Do NOT
tighten the screws.
Test the fi t by opening
and closing the StarGate
several times.
For a fi nal adjustment,
make sure that the back
plate is fl ush against the
RETMA rail and the back
plate is square to the
RETMA rails.
Once positioned, tighten
down the screws.
Test the adjustment by
opening and closing the
StarGate display several
times.
If there is any binding,
check for alignment and
repeat the previous step.
INSTALLATION