Z Corporation ZPrinter 650, Руководство по устранению неисправностей, Страница: 18 / 68

09915 ZPrinter 650 Troubleshooting Guide
40007 AUTOALIGN: alignment of Axis x failed
This error is axis specific (Axis0 or Axis1) and is caused by the sensors lack of ability to properly
align the heads.
Monitor Read-Out or
Secondary
Symptom Cause / Problem Solution
Reference
Documents
40007 AUTOALIGN:
alignment of Axis x failed
Dirty sensor Window Clean Window and Retry
09577 ZPrinter650 User
Manual
(Figure 7 )
After performing the above step try performing a service print head and an alignment. Watch the alignment pattern for
print quality. If the machine performs both tasks the problem should be solved.
40007 AUTOALIGN:
alignment of Axis x failed
Build bed is not Flat Perform Fill Bed
09577 ZPrinter650 User
Manual
40007 AUTOALIGN:
alignment of Axis x failed
Poor Spread "See Spread Issues"
"See Spread Issues"
(figure 18 )
After performing the above step try performing a service print head and an alignment. Watch the alignment pattern for
print quality. If the machine performs both tasks the problem should be solved.
40009 AUTOALIGN:
alignment of Axis x failed
Stripy printing
"See Part Quality
Troubleshooting"
"See Part Quality
Troubleshooting"
(Figure 8 )
After performing the above step try performing a service print head and an alignment. Watch the alignment pattern for
print quality. If the machine performs both tasks the problem should be solved.
40007 AUTOALIGN:
alignment of Axis x failed
Dirty Sensor on Pogo or oil
has leaked in the carriage
Clean sensor on Pogo with
alcohol and clean inside
the carriage then retry
85022 ZPrinter 650 Pogo
PCB Removal and
Replacement
(Figure 9 and 9.1)
40007 AUTOALIGN:
alignment of Axis x failed
Pogo Card is crooked or
sensor is not snapped in
Realign the pogo card
85022 ZPrinter 650 Pogo
PCB Removal and
Replacement
(Figure 9 and 9.1)
After performing the above step try performing a service print head and an alignment. Watch the alignment pattern for
print quality. If the machine performs both tasks the problem should be solved.
40007 AUTOALIGN:
alignment of Axis x failed
Bad Pogo PCB Replace 50019 Pogo PCB
85022 ZPrinter 650 Pogo
PCB Removal and
Replacement
Stripy printing is one of the most common causes of this error. The key to troubleshooting this error is defining the
problem that you are dealing with. You must differentiate weather the problem is caused by stripy printing or an axis
problem. When this error is encountered the machine will do a stripe test over the alignment pattern. If that stripe test
looks good then the problem may be related to a dirty sensor window or movement problems with the indicated axis.
18