Yokomo YZ-114 Plus, Инструкция по эксплуатации

Страница: 19 / 24

13 · · 12 YZ-114 PLUS YZ-114 PLUS
■
Using the Battery Memory Profile
The YZ-114PLUS can store up to 10 different charge/discharge profiles. These profiles can be
easily and quickly recalled to eliminate the need to enter charging parameters each time the
charger is being used.
Tochange a parameter value in a program, press theENTER button once in order to edit the
value. While the value is blinking the value can be changed by pressing the
－
and
＋
buttons.
Once the desired value is chosen, pressing the ENTER button once again to store the value.
■ Saving to Battery Memory Profile
●
Stopping the Process
To stop the process in progress, press the STOP button.
● Process Completion
When the charge or discharge process completes, the charger will make an audible chime.
NiMH
NiCd
RE-PEAK
CYCLE
Pb
Battery
Type
Performs a normal charge on LiPo/LiFe/LiIon/LiHV batteries.
Performs a discharge of LiPo/LiFe/LiIon/LiHV batteries.
Performs a fast charge. The charge may not achieve full capacity;
however, charge time will be reduced. (Use only on batteries which
explicitly state support for fast charge.)
Performs a balance charge on LiPo batteries.
Charges NiMH and NiCd batteries using the set charge current.
In this mode, the charger will check the condition of the battery and
performs charging as necessary.
Note: To avoid causing damage to batteries by excessive current, be
sure to set an appropriatecharge current. Some batteries which have
low resistance and capacity can result in higher current.
In re-peak charge mode, the charger can peak charge the battery 1~3
times in a row automatically. This can be useful to ensure that the
battery is fully charged, and to check how well fast charges can be
accepted by the battery.
In cycle mode, a "charge→discharge" or "discharge→charge" cycle will
be performed 1~5 cycles continuously, which can stimulate the battery
by refreshing and balancing it.
LiPo
Lilon
LiFe
LiHV
CHARGE
DISCHARGE
STORAGE
FAST CHG
BALANCE CHA
CHARGE
AUTO CHG
DISCHARGE
CHARGE
DISCHARGE
Performs a charge/discharge on lithium batteries which will not be
used for a long time.
Discharges NiMH and NiCd batteries.
Charges Pb batteries.
Discharges Pb batteries.
WARNING: When using LiHV mode, be certain that the LiPo battery is a HV (high-voltage) type which
is 3.8 V per cell. NEVER attempt to use the LiHV mode with conventional 3.7 V cellLiPo batteries, as it
can cause fires and explosions leading to personal injuries and property damage.
Program Description
Enter the battery memory program.
Next, select the battery type, by choosing one of LiPo, LiFe, LiIon,
LiHV, NiMH, NiCd, orPb.
Select the battery voltage and number of cells (1S
～
6S)
Set the charge current. (0.1 A
～
6.0A)
Set the discharge current. (0.1 A
～
2.0A)
Set the discharge voltage (3.0
～
3.3 V per cell)
Set the end voltage while charging. (4.18
～
4.25 V)
Caution: Inappropriate use of this feature may lead to over-charging
the battery, causing risk of permanent damage and possible fire and
explosion.
Press the ENTER to save the program.
GETTING STARTED GETTING STARTED
■
Program Listing
The following are a listing of charge and discharge programs available for the different battery types.