Yokomo YZ-114 Plus, Инструкция по эксплуатации

Страница: 21 / 24

BATTERY METER
K e y B e e p O N
B u z z e r O N
OFF/ON
Sets whether or not the beep tone should be
played each time the the key button is
pressed. Also affects the beep and melody
tones.
I n p u t . P o w e r L o w
C u t - O f f 1 1 . 0 V
10.0-11.0V
The minimum allowable DC input voltage.
When the voltage drops below this voltage,
the charger will terminate the current process
to protect the DC input source.
L o a d F a c t o r y S e t
E n t e r
V e r s i o n
H W : 1 . 0 0 F W : 1 . 1 0
Press ENTER to perform a factory reset to
revert all settings to default values.
Displays the hardware and firmware versions
of the charger.
B a l . C o n n e c t i o n
Sets whether or not the balance charge cable is
required or not when performing processes
other than balance charging. When this is ON,
balance charge cable will be required even for
processes other than balance charging.
画面 設定値 説明
Using the Battery Meter program, one can check the total voltage of the battery, along with the
highest and lowest voltages, and the voltage of each individual cell. A balance cable must be
connected to use this feature.
Select the "BATT METER" program from the Battery Program menu,
and press ENTER button.
The voltage of each cell will be displayed.
Pressing the ＋/－ buttons, will toggle between the previous screen
and this screen which shows the battery total voltage, and highest and
lowest cell voltage.
SYSTEM SETTINGS
N i M H S e n s i t i v i t y
D . P e a k D e f a u l t
N i C d S e n s i t i v i t y
D . P e a k D e f a u l t
Default: 4mV/Cell
5-15mV/Cell
The value for the delta peak voltage should
reach which the charger will consider
thebattery has been fully charged. This option
is only for NiNH and NiCd batteries.
17 · YZ-114 PLUS · 16 YZ-114 PLUS