IM 05C01F12-41E
20
Step 1:
Press the key for at least 1 second to reset
the program operation, and confirm that the UP150
shows the operating display
➀
,
➁
or
➂
.
Confirm that “RUN”
lamp is not lit.
Step 2:
To enter the program parameter setting display,
do key operation as follows.
[1] Press the key for at least 3 seconds to display
“PRG”.
[2] Press the key once to display “1”. The period
flashes while the value is being changed.
[3] Press the key once to display “SSP” in the
program parameter setting display.
Step 3:
Set the parameters from “SSP” to “WTZ” by using the
, and keys.
• Use the or key to change the value
of parameters.
• Use key to register the setpoint.
• When “creating program” is finished,
press the key for at least 3 seconds
to return to the operating display
➀
.
The period flashes
during change.
The period is lit or
goes out after
registration.
EV
RUN
EV
RUN
EV
RUN
To delete a part of the program pattern, set the segment time of the segment to be deleted (“TMn” n=1 to 16) to
OFF, referring to “
■
Creating the program.”
Note : If the segment time of the halfway segment is set to OFF, all of the following segment will not be dis-
played. Be careful!
■
Creating the Program
Before creating the program, reverify the Measured Input Type (IN), Maximum Value of Measured Input
Scale (RH), Minimum Value of Measured Input Scale (RL), and Control Mode (CTL) parameters.
■
Deleting the Program Segment
