YOKOGAWA DTSXL, Руководство пользователя, Страница: 94 / 289

< PART – B Software >
B-11
IM 39J06B40-01EN 14th Edition: May 30, 2022

Connect the DTSX3000 and PC using an Ethernet cable.
Perform connection as described below.
The PC installed with the IP Address Configuration Tool runs as a DHCP server to
assign IP addresses to DTSX3000 units.
To avoid problems arising from having two DHCP servers running on the same network,
connect the PC and the DTSX3000 one-to-one.

Boot up the DTSX3000 in IP address setting state.
Boot up the DTSX3000 in IP address setting state.
- Should you forget a previously configured IP address, put the system in IP address
setting selected state when it transits to boot mode selection state immediately after
power up. If the system is left in this state for more than 5 seconds, it goes into IP
address setting state.
The state of the DTSX can be determined from the state of its LED indicators.
Boot mode selection state
: HRDY and RDY blink fast.
IP address setting selected state : HRDY blinks fast; RDY blinks.
In IP address setting state, the system broadcasts its MAC address according to the
Bootp protocol and waits to be assigned an IP address.
SEE ALSO
For details on the system operating states, see Subsection B4.1, “Operation Overview.”