YOKOGAWA DTSXL, Руководство пользователя, Страница: 65 / 289

< PART – A Hardware >
A-42
IM 39J06B40-01EN 14th Edition: May 30, 2022
A5. Wiring
IMPORTANT
- Do not bend or press the power cable or the signal cable if the ambient
temperature is minus 20 degrees Celsius or below.
- Cables with the temperature rating of an ambient temperature plus 10 °C or more
must be used.
A5.1. Power Supply Wiring
The following describes the power supply wiring for a power supply module that has
been installed.
SEE ALSO
For details on wiring of power supply modules, see the STARDOM FCN/FCJ Guide (IM 34P02Q01-
01E).

Wiring Specification and Terminal Preparation
For the wire terminals, use crimp-on terminal lugs with insulation sleeve. Be sure to use
ring tongue terminal and crimping tools of the same brand.
●
Applicable Cables
Insulated cables for industrial equipment such as;
- 600 V polyvinyl chloride insulated wires (IV); JIS C3307
- Polyvinyl chloride insulated wires for electrical apparatus (KIV); JIS C3316
- 600 V grade heat-resistant polyvinyl chloride insulated wires (HIV); JIS C3317
- Heatproof vinyl insulated wires VW-1 (UL1015/UL1007)
●
Recommend Sizes
0.5 mm 2 to 2 mm 2 (AWG 20 to 14)
●
Terminal Preparation
Use ring tongue terminal for M4 terminals, with the outer diameter of the lug tip (outer
terminal diameter) not exceeding 8.5 mm, and with an insulation sleeve.
Figure Ring Tongue Terminal
Outer Terminal diameter
Hole diameter
Terminal length
Insulation sleeve
Internal diameter