YOKOGAWA DTSXL, Руководство пользователя, Страница: 74 / 289

< PART – A Hardware >
A-51
IM 39J06B40-01EN 14th Edition: May 30, 2022
SEE ALSO
The following optical fiber and optical connector are recommended for use with the DTSX3000.
- Refer to GS39J06B40-01EN
4. Ensure that the end face of the optical connector is free of dirt or scratches.
If visual inspection is inadequate, we recommended using an observation
microscope to check the end face of the optical connector.
5. Clean the optical connector end face.
Use a cleaner dedicated for cleaning optical fiber for this purpose.
Although the E2000/APC optical connector is provided with a protective shutter to
protect its end face, if it has been stored in a dusty place or for a prolonged period,
it must be cleaned to remove any dust which might have entered through gaps on
the shutter.
6. Remove the protective cap from the optical output connector on the DTSX3000.
Do not discard the removed cap but store it in a plastic bag or otherwise to protect
it against dust. It should be replaced when the sensor optical fiber is disconnected
from the DTSX3000.
Do not remove its protective cap if the optical output connector on the DTSX3000
is not used.
7. Connect the E2000/APC optical connector to the DTSX3000.
The figures below show how to mate the optical connectors together at the
DTSX3000.
Hold the optical connector of the optical fiber with your two fingers (see Figure A)
and ensure that it is correctly oriented (the lever side up) to the optical output
connector on the DTSX3000 and mate them together (see Figure B).
A clicking sound confirms that the optical connectors are properly interlocked
properly (see Figure C).
To confirm proper locking, hold the sides of the optical connector of the optical fiber
with your two fingers and pull lightly to check that it is securely fastened.
When attaching the optical connector of the optical fiber to or detaching it from the
optical connector on the DTSX3000, always push or pull perpendicularly to the
panel face of the DTSX3000. Do not apply force at an angle when and after the
optical connectors are mated.
Figure A Being Mated