5
Precision Making
Setup
2. A simple acquisition
ScopeCorder introduction workbook
Copyright © Yokogawa Electric Corporation
Prerequisite:
You may wish to perform a factory reset (
) before this exercise to ensure your
ScopeCorder matches the setup of the ScopeCorder used in these exercises.
In this exercise you will make a simple waveform acquisition. Please connect CH1 to the PROBE
COMP pins on the front of the ScopeCorder using a suitable 10:1 or 1:1 probe / test lead. Leave all
other channel inputs disconnected. Press CH1 and adjust PROBE to either 10:1 / 1:1 as appropriate
for the input lead-set being used.
Follow these keystrokes:
Active Channels
If other channels are still enabled, please
turn them OFF by double-pressing each one
of the corresponding channel buttons, such
as
CH 2
, etc.
PROBE COMP connection
DONE!
Results are displayed
on the next page.