7
IM 701510-01E
How to Use this Manual
Structure of the Manual
This User’s Manual consists of 16 chapters, an Appendix and an Index as described below.
Chapter Title
Description
1
Functions
Describes measurement principles and functions. Although this
section does not give a description of the operating methods, it
will help you to understand the basic operations.
2
Name and Use of
Gives the name of each part and describes how to use it.
Each Part
The corresponding reference pages for panel keys and the
rotary knobs are also given.
3
Before Starting
Describes points to watch during use and describes how to
Observation and
install the instrument, connect the power cord, turn the power
Measurement of
switch ON/OFF and connect probes as well as how to set the
Waveforms
date and time.
4
Common Operations
Describes the operations used to make settings, such as start/
stop acquisition, auto set-up and initialization of each setting as
well as operations, such as snapshot, clear trace and calibration,
that are used frequently during operation.
5
Setting the Vertical
Describes how to turn channels ON/OFF, how to make
and Horizontal Axes
settings, such as input coupling, probe attenuation and vertical
sensitivity, that are related to the vertical axis (voltage axis), as
well as how to make settings related to the horizontal axis (time
axis).
6
Activating a Trigger
Describes trigger setting operations, such as those for setting
trigger mode, trigger type, trigger source and trigger level, that
enable you to determine acquisition timing.
7
Changing Acquisition
Describes how to make acquisition condition settings, such as
and Display
acquisition mode, sampling mode, input filter and hysteresis,
Conditions
as well as how to make display condition settings, such as
waveform expansion, interpolation, accumulation, X-Y display
and graticule.
8
Analyzing Waveforms
Describes how to measure waveforms using cursors, perform
automatic measurement of waveform parameters and waveform
math, and how to display the power spectrum obtained by FFT
computation.
9
Performing a
Describes how to perform a GO/NO-GO action by setting the
GO/NO-GO Action
waveform zone or setting limits for waveform parameters, then
detecting whether the input signal waveform is within the
specified range (zone or limits).
10
Outputting Displayed
Describes how to output displayed waveforms (screen
Waveforms and
hardcopy) and set-up information to the built-in printer or
Setting Parameters
plotter connected to the GP-IB interface.
to the Printer/Plotter
11
Storing and Recalling
Describes how to store displayed waveforms or settings in the
Data from the Internal
internal memory, how to recall stored waveform data and
Memory
display the waveforms, and how to recall settings and change
them.
12
Saving and Loading
Describes how to save waveform data or set-up data to a floppy
Data from a Floppy
disk, how to load saved data, how to initialize a floppy disk and
Disk
how to delete data.
13
Saving and Loading
Describes how to save waveform data or set-up data to a SCSI
Data from a SCSI
device, how to load saved data, how to initialize a SCSI device
Device
and how to delete data.
14
Other Operations
Describes operations such as those required for trigger output.
15
Troubleshooting,
Describes how to diagnose the cause of trouble and how to
Maintenance and
correct it, as well as describing each message that may appear
Inspection
on the screen and how to perform a self test.
16
Specifications
Describes the specifications.
Appendix
Shows a menu map, describes the relationship between the time
axis, sample rate and record length, and describes the data
format which must be specified when waveform data is saved.
Index
Important terms used in this manual with corresponding
reference page numbers are given.