1-2
IM AQ1300-01EN
1.2 Test Menu (Top Menu)
Auto
Select Auto to perform automatic testing on a device according to the test items in the selected setup
file. You can execute up to eight test items in order or at the same time. You can display pass/fail
results for each test and automatically save the measurement results to a file.
You can configure setup files and test items using the setup software, which runs on Windows PC.
Auto(Remote)
Select Auto(Remote) to use a master device to perform automatic testing of a remote slave device
according to the test items in the selected setup file. You can execute up to eight test items in
order or at the same time. You can display pass/fail results for each test and automatically save the
measurement results to a file.
Because the master device controls the slave device remotely, a single person can perform the tests.
The slave device can be configured remotely, and its measurements can be collected by the master
device.
You can configure setup files and test items using the setup software, which runs on Windows PC.
Manual
Select Manual to perform manual testing on a device using a single test item in the selected setup file.
You can generate traffic and perform analysis in greater detail than you can when you select Auto or
Auto(Remote).
You can configure setup files and test items using the setup software, which runs on Windows PC.
OPM (AQ1300 Option)
Select OPM to measure optical input power using the optical power meter.
RFC2544 (AQ1300 Option)
An automated test function in conformity with RFC2544, the standard benchmarking methodology for
a performance examination of Ethernet service and network systems.
• Throughput: Maximum frame transfer rate without frame loss.
• Latency: Delay time of a frame
• Frame loss rate: Incidence rate of frame loss with excess traffic.
• Back-to back: Maximum burst value not causing a frame loss.
• Packet jitter: Variation of latency
VLAN Test
The VLAN Test is used to check the VLAN trunk configuration. You can compare the VLAN ID list that
you plan to receive with the actual received VLAN ID list. The VLAN Test consists of transmission,
reception, analysis, and result display and storage features.
E-OAM Test
Ethernet Operation, Administration and Maintenance (hereafter referred to as E-OAM) tests can be
performed in compliance with the ITU-T Y.1731 Recommendation and IEEE802.1ag Standard.
This is supported in firmware version R1.10.01.001 and later.
• CC (continuity check) test: Connection check between network devices
• LB (loop back) test: Response check between network devices
• LT (link trace): Link check between network devices
System
Select System to configure the AQ1300 Series system settings.
Language, Beep, USB Function, Date & Time Set, Power Save mode, Network Setup, Factory Setting,
Product Info. display, Selftest, Version Up
