SMARTBENCH V1.0
Unit 1 Westfield Court | Barns Ground | Clevedon | Bristol | BS21 6FQ | UK
Tel No: +44 1275 390721 | Email: [email protected]
18
Set Z datum (start point for the job)
Once the X/Y datum is defined, the tip of the router cutter needs to be registered relative
to the material. This is referred to as setting the Z datum, and should be done near the X/Y
datum. Start by going to the X/Y datum:
•
Go to the Map Screen (1)
•
Press
‘Go to X/Y Datum’ (2) to place the Z Head at the X/Y datum
Содержание SMARTBENCH
Страница 1: ...Quick Start Guide v1 2...