Yealink MeetingSpace VC500, Руководство администратора

Страница: 25 / 281

Getting Started
9
Getting Started
This chapter provides basic information and installation instructions for Yealink VC800/VC500
systems in the following sections:

System Initialization

Setup Wizard

Enabling Communication with Remote Systems

Placing a Test Call
System Initialization
Once you have power on the system, it will begin its initialization process.
During the initialization process, the following events take place:
Loading the ROM file
The ROM file sits in the flash memory of the system. Systems come from the factory with a ROM
file preloaded. During initialization, systems run a bootstrap loader that loads and executes the
ROM file.
Configuring the VLAN
If the system is connected to a switch, the switch will notify the system about the VLAN
information defined on the switch.
Querying the DHCP (Dynamic Host Configuration Protocol) Server
The system is capable of querying a DHCP server. DHCP is enabled on the system by default.
The following network settings can be obtained from the DHCP server during initialization:

IP Address

Subnet Mask

Gateway

Primary DNS (Domain Name Server)

Secondary DNS
You need to configure the network settings of the system manually if the DHCP server does not
provide them. For more information on configuring network settings manually, refer to
Configuring Network Settings Manually on page 18 .