YATO YT-82950, Руководство пользователя

Страница: 11 / 56

11
O R I G I N A L I N S T R U C T I O N S
GB
Make sure that the power switch has been locked before starting the device i.e. The lock has been moved to the right as far as it
will go when viewed from the front of the compressor (VI).
The product must be started by pressing the button marked SET. You can change the pressure using the buttons marked “+” and
“-”. The button marked “+” increases the pressure setting and the button marked “-” decreases the pressure setting. The setting is
visible on the display. When the setpoint indication stops fl ashing, it means that the target pressure has been set.
Install the hose to the gun and, if necessary, the adapter. Install the hose to the product to be in fl ated.
Unlock the power switch by sliding the lock to the left as far as it will go (VI).
Press and release the pressure on the power switch; the compressor will start pumping. The pressure increase can be observed
on the display. When the target pressure is reached, the gun will automatically stop pumping.
The pumping process can also be interrupted manually at any time by pressing the power switch.
When pumping is fi nished, secure the power switch with a lock against accidental pressing and then disconnect the hose from
the pumped product. A short hiss of expanding air may be heard when disconnecting the hose. This is a normal phenomenon of
expansion of the air in the hose.
The product is switched o ff by pressing and holding the SET button until the display goes o ff .
Changing the pressure unit
When the display is switched on, press the SET button; the indication of the pressure unit changes in the following cycle: PSI –
BAR – KPA – KG/CM
2
. The pressure unit symbol is shown on the display.
MAINTENANCE, TRANSPORT AND STORAGE
The product does not require any special maintenance. Clean the casing of the product with a slightly damp cloth, then dry or
leave to dry after fi nishing work. Never immerse the product in water or any other liquid. Do not use alcohol, acids or corrosive or
abrasive agents to clean the product.
Always carry the product by holding the handle or, if there is no handle, by holding the casing. Never carry the product by holding
the hose and/or the power cord. Always carry the product unplugged with the plug and the clamps disconnected from the power
source.
It is recommended to store and transport the product in the packaging supplied with the product or in other packaging protecting
it from moisture and dust. The temperature in the storage place should be in the range of 0 - 40 O C and the relative humidity RH
< 85%, without condensation.