20
YASKAWA
TOEPC71061782C GA800 Drive Installation & Primary Operation
Figure 6.12 Reattach the Front Cover
3.
Reattach the keypad to the original position.
Remove the Terminal Cover
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION
Crush Hazard. Loosen the cover screws. Do not fully remove them. If you fully remove the cover screws,
the terminal cover can fall and cause moderate injury.
Figure 6.13 Loosen the Terminal Cover Mounting Screws
2.
Pull the terminal cover away from the drive.
Figure 6.14 Remove the Terminal Cover
Reattach the Terminal Cover
Wire the drive and other peripheral devices then reattach the terminal cover.
Note:
• Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
• Make sure that you do not pinch wires or signal lines between the wiring cover and the drive before you reattach the cover.
• Tighten the screws to a tightening torque of 0.98 N
∙
m to 1.33 N
∙
m (8.67 lbf
∙
in to 11.77 lbf
∙
in).
