3
Power supply PS 307
3.1 Safety Information
The power supplies are constructed and manufactured for:
n
DC 24V supply of System 300 components.
n
Installation together with other System 300 components on one panel.
n
Installation in a cubicle with air condition.
n
Industrial usage.
Using the power supply:
n
Install the power supply together with your System 300 modules on a profile rail. In
this case the power supply has to be plugged on the outermost rim of your System
300, because otherwise the backplane bus is interrupted.
n
The power supplies are not connected to the backplane bus. When selecting the
installation position please take care that the power supply is cooled sufficiently
during operation.
In the following you will find the precautions you should take into account by using the
System 300 power supplies.
CAUTION!
–
The power supplies may only be installed in dry environment where it
can only be accessed by trained personnel!
–
The power supplies are not certified for explosive environments (EX-
Zone)!
–
Before installing or overhauling the System 300V, the power supplies
must be disconnected from voltage (pull the plug or remove the fuse)!
–
Installation and modifications only by properly trained personnel!
–
Due to the compact design, the contact and fire protection to guar-
antee sufficient cooling can not be obeyed. For this reason the fire
protection has to be guaranteed by the construction of the environ-
ment of the power supply (e.g. installation in a cubicle that obeys the
fire protection rules)!
–
The national rules and regulations of the respective country must be
satisfied (installation, safety, EMC ...).
Application fields
Assembly
VIPA System 300
Power supply PS 307
Safety Information
HB130 | PS | 307-1xA00 | en | 18-01
17
