5 Mechanical & Electrical Installation
YASKAWA ELECTRIC
SIEP YEUOCL1 01A CANopen-Lift Communication Option Installation Manual
13
4.
Fix option card to the inverter with screw (2) additionally. Connect the ground wire (F) to inverter ground
terminal (D).
Note:
There are only two screw holes on the drive for ground terminals. If three different option cards are connected, two of the
ground wires will need to share the same ground terminal.
A - Connector CN5-C
B - Connector CN5-B
C - Connector CN5-A
D - Drive grounding terminal (FE)
E - Option cards
F - Ground wire
G - Opening for cable lines (use
cutter to create the opening)
H - Operator
I - LED labels
J - Front cover
Figure 5.1 Installing the Option Card
5.
Prepare the 9 pin D-sub network cable connectors.
For inverter drives CIMR-Lx4F0002 to 0023: the network cable should be routed to the outside through
the openings at the left side (G) of the front cover. Make sure no sharp edges remain.
For Inverter drives 4F0031 to 0165: enough space to keep all wiring inside the unit is available.
A - Opening for network cables
(CIMR-Lx4F0002 to 0023)
B - Space for wiring (CIMR-Lx4F0031
to 0165)
Figure 5.2 Network Cable Routing
6.
Plug in the 9 pin D-sub network cable connector to the option.
7.
Reinstall the front cover back onto the drive as it was before.
8.
Attach the LED label (I) as shown in
Figure 5.1
.
9.
Switch on the drive power supply.
10.
Set inverter parameter as follows:
F
A
E
H
I
B
C
D
G
J
2
1
ERR
RUN
A
B