YASKAWA CC-Link SI-C3, Руководство по установке

Страница: 50 / 139

8 CC-Link Data List
50 YASKAWA TOEP C730600 83A CC-Link Installation Manual
Remote
Regis
ter
Name Description Request Flag
RW
W2
Com
mand
Code
• Sets the command code to execute functions, for
example the fault reset, fault history, and parameter
read.
Note:
Refer to the MEMOBUS/Modbus Data Table in
Appendix C of the instruction manual for the drive
the CC-Link option is connected to for a list of
monitor data using the MEMOBUS/Modbus
message area.
• When RYF (command code execution request flag)
is enabled, the drive executes the specified
command. When the command is carried out, RXF
switches ON.
Note:
Adjust the value set to RW
W3
(write data)to match
changes to any parameter settings.
RYF (Command Code Execute
Request)
RW
W3
Write
Data
•
Sets the value to be used along with RW
W2
(Command Code) as needed.
• You must enable RYF (command code execution
request flag)after the command code and write data
have been set.
*1 You can write data to the EEPROM used for the drive 100,000 times. Do not use this write command
frequently.
Drive → PLC
Table 8.6 Remote Register (Drive → PLC)
Remote
Regis
ter
Name Description Check Flag
RW
R0
Monitor
Data
• Monitor data is stored according to RW
W0
(Monitor
Code).
•
Monitor data is updated while RYC (monitor execute
request flag) is enabled. RXC (while monitoring)
remains ON as data is updated.
RXC (while monitoring)
RW
R1
Output
Fre
quency
• Motor revolutions or output frequency has been set
without errors.
Sets data contents with RYB (Motor Revolutions/
Output Frequency Switch).
•
When RYB is disabled, the output frequency are
stored.
Set in the drives specified by
o1-03 [Frequency
Display Unit Selection] in output frequency.
Example: When o1-03 = 0 [0.01 Hz] , the frequency
is displayed in 0.01 Hz.
When
o1-03 = 2 [min -1 (r/min) units] , the frequency
is displayed as min -1 .
RXB (actual motor rotations)