Yamato Neocool CF302L-A, Инструкция по эксплуатации

Страница: 23 / 47

19
5. OPERATION PROCEDURES
Operation procedure
1. Turn on power
1. Turn ELCB ON (|).
2. Turn the Power switch ON (|).
Temperature
display : Shows temperature reading
following the software version
"V. ○.○"
Ref lamp : Flashing
(goes off after about three minutes)
indicates flashing.
2. Set temperature
1. Press key.
Temperature
display : Current set temperature flashes.
2. Set
∧ ∨
temperature using the keys.
3. Press key to finalize.
Temperature
display : Shows temperature reading

If not operated for about one minute while
temperature setting is on screen, display reverts to
the previous screen.
3. Run refrigerator
Press key for one second.
Run/ Stop lamp : ON
Ref lamp : ON
Refrigeration unit : Run
 Refrigerator will operate when Ref lamp stops flashing
<To stop>
Press key again.
Run/ Stop lamp : OFF
Ref lamp : Flashing
(goes off after about three minutes)
Refrigeration unit : Stop

Ref lamp indicates the operating state of the refrigerator.
OFF: Standby (ready for operation)
ON: In operation
Flashing: In preparation. It takes about three minutes from the refrigeration stop to restart
operation for protecting the refrigerator.
4. Start circulation
Press key for one second.
Pump lamp : ON
Circulation pump : Run
<To stop>
Press key again.
Pump lamp : OFF
Circulation pump : Stop
 When changing temperature setting, in Step 2 while the value is flashing, cooling operation can
start or stop. The setting change will be finalized with the value at the time of start or stop of the
operation. It is also possible to start or stop cooling water circulation operation at the time of
temperature setting change. Still setting value keeps flashing.
Note) Always open the optional flow rate valve, if installed, at the discharge port when operating the
circulation pump. See "3. External circulation path" (P.17)
Press 1 sec.
Press 1 sec.
1