4 - 30
CHAS
FRONT AND REAR BRAKES
EAS00607
ASSEMBLING AND INSTALLING THE
FRONT BRAKE MASTER CYLINDER
WARNING
_
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake
components.
Recommended brake fluid
DOT 4
1. Install:
• brake master cylinder
1
NOTE:
_
• Install the brake master cylinder holder with
the “UP” mark facing up.
• Align the end of the brake master cylinder
holder with the punch mark
a
on the right
handlebar.
• First, tighten the upper bolt, then the lower
bolt.
2. Install:
• copper washers
• brake hose
• union bolt
WARNING
_
Proper brake hose routing is essential to
insure safe motorcycle operation. Refer to
“CABLE ROUTING” in chapter 2.
NOTE:
_
• While holding the brake hose, tighten the
union bolt as shown.
• Turn the handlebars to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables,
leads). Correct if necessary.
T
R
.
.
9 Nm (0.9 m · kg, 6.5 ft · lb)
New
T
R
.
.
30 Nm (3.0 m · kg, 22 ft · lb)
Содержание YZF-R1P 2001-2003
