Yamaha YW50AP, Руководство по обслуживанию

Страница: 57 / 214

INSP
ADJ
3-18
STEERING ADJUSTMENT
1. Check:
8
Steering assembly bearings
Gap the bottom of the forks and gently
rock the fork assembly back and forth.
Loosen
→
Adjust.
***************************************
Adjustment steps:
8
Remove upper cover, lower cowling, leg
shield 1,2. refer to “COVER AND PANEL” sec-
tion.
8
Remove all ringnuts using ringnut wrench.
Ring nut wrench:
YU-33975
8
Tighten the ring nut 3
1
using nut wrench.
22 Nm(2.2 m.kg, 16 ft.lb)
NOTE:
Set the torque wrench to the ring nut wrench
so that they form a right angle.
8
Loosen the ring nut 3
1
1/4 turn.
8
Install rubber ring
2
and ring nut 2
3
, then
tighten the ring nut 2 until it contacts with
rubber ring.
c C
Aligning the slot of ring nut 2 with the slot of
ring nut 3. If not, slightly tighten ring nut 2 un-
til the slots alignment.
8
Install special washer
4
NOTE:
Insert the projections of special washer into the
slots of ring nut 3, 2
8
Install ring nut 1
5
66Nm(6.6 m.kg, 47.8 ft.lb)
8
Move the handlebar up and down, and/or
back and forth. If handlebar play is excess,
remove the front fork assembly and check
the balls/ball races. Refer to chapter 6.
***************************************
STEERING ADJUSTMENT
1
T
R
.
.
2
3
4
5
T
R
.
.