Yamaha YK250XGC, Руководство по установке

Страница: 16 / 96

Safety Instructions
S-8
4.2 Design
4.2.1 Precautions for robots
Provide safety measures for end effector (gripper, etc.) 1.
• enD effectors must be DesigneD anD manufactureD so that they cause no hazarDs (such as a loose
worKPiece or loaD) even if Power (electricity, air Pressure, etc.) is shut off or Power fluctuations
OCCUR.
• If ThE ObjECT gRIPPED by ThE EnD EffECTOR MIghT POSSIbly fly Off OR DROP, ThEn PROvIDE aPPROPRIaTE
SafETy PROTECTIOn TakIng InTO aCCOUnT ThE ObjECT SIzE, WEIghT, TEMPERaTURE, anD ChEMICal PROPERTIES.
Provide adequate lighting 2.
Provide enough lighting to ensure safety during work.
Install an operation status light 3.
install a signal light (signal tower) at an easy-to-see Position so that the oPerator will be aware of
the robot stoP status (temPorarily stoPPeD, emergency stoP, error stoP, etc.).
Do not use robots for tasks requiring motor thrust 4.
avoid using the belt-driven robots for tasks which make use of motor thrust (press-fitting, burr removal, etc.).
These tasks may cause the robot to malfunction.
Clean work tools 5.
Work tools such as welding guns and paint nozzles mounted on the robot manipulator tip should preferably be cleaned
automatically when needed.
4.2.2 Precautions for robot controllers
Emergency stop input terminal 1.
EaCh RObOT COnTROllER haS an EMERgEnCy STOP InPUT TERMInal TO TRIggER EMERgEnCy STOP. USIng ThIS
TERMInal, InSTall a SafETy CIRCUIT SO ThaT ThE SySTEM InClUDIng ThE RObOT COnTROllER WIll WORk SafEly.
Maintain clearance 2.
Do not bundle control lines or communication cables together or in close to the main power supply or power
lines. Usually separate these by at least 100mm. failure to follow this instruction may cause malfunction due to
noise.