Yamaha YDX-MORO Pro, Инструкция по сборке

Страница: 10 / 20

INSTALLING THE INCLUDED PARTS
– 8 –
7
9
After installing the button cell battery, install the
display unit onto the bracket following the
removal procedure in reverse order.
5. Installing the display unit’s
Maintain a clearance of 1 to 2 mm between the
bracket of the compact multifunction meter set
a
and the handlebar holder
b
as shown, install
the set, and then tighten the bolt
c
to the spec-
ified torque.
After installing, remove the protective film.
6. Installing the front reflector
Install the front reflector
1
, stay
2
, and screw
3
as shown, and then tighten them together to
the specified torque.
TIP
Adjust so that the front reflector
1
faces straight
ahead, then tighten the screw.
7. Installing the bell
Install the bell
1
in the shown, then tighten it
with the screw
2
.
8
Install the button cell battery with the plus
(+) mark facing upward.
8
Check that the O-ring
g
is properly
installed.
NOTICE
a
b
c
1
〜
2mm
Tightening tor qu e 3 .8 N·m (0. 3 8 kgf·m, 2.8 l b ·ft)
1
2
3
Tightening tor qu e 1.5 N·m (0.15 kgf·m, 1.1 l b ·ft)
1
Front reflector 1 A
2
Stay 1 A
3
Screw 1 A
1
2
Tightening tor qu e 0.8 N·m (0.08 kgf·m, 0.59 l b ·ft)
1
Bell 1 A
2
Screw 1 A
X1V-28107-10.book 8 ページ ２０２０年８月３日 月曜日 午後４時１１分