Yamaha YDX-MORO Pro, Инструкция по сборке

Страница: 8 / 20

INSTALLING THE INCLUDED PARTS
– 6 –
7
9
TIP
If the lever
d
of the front axle
2
is too hard and
cannot be lowered, or if it is too loose and cannot
be lowered for it to be locked, turn the lever
d
again to loosen or tighten it, adjusting so that it can
be fastened securely.
2. Installing the handlebar stem
Position the handlebar stem
a
in a straight line
with the front wheel.
Tighten the bolts
b
and
c
, in that order, to the
specified torques.
3. Installing the handlebar
Install the handlebar
a
so that the 3rd horizon-
tal line from the top of the alignment mark
b
shown is positioned at the lower end of the hole
in the upper handlebar holder
c
, and then
tighten the 4 bolts
d
of the handlebar holder
c
to the specified torque.
8
Position the lever when it cannot touch
obstacles while the bicycle is moving. If not,
the lever could be unlocked unexpectedly,
causing the front wheel to come off, result-
ing in an accident with severe injury or
death.
8
Fasten the lever
d
at position where the tip
does not touch other parts when the lever
d
is lowered.
8
Fasten the lever
d
facing backward from
the direction of travel in such a way that it
cannot easily touch obstacles that might be
encountered while riding.
WARNING
b
a
c
Tightening tor qu e 8 N·m (0.8 kgf·m, 5.9 l b ·ft)
Tightening tor qu e 2.5 N·m (0.25 kgf·m, 1.8 l b ·ft)
a
c
d
d
b
Tightening tor qu e 6 N·m (0.6 kgf·m, 4.4 l b ·ft)
The handlebar
a
should not touch the frame
when it is turned fully to the left or right.
NOTICE
X1V-28107-10.book 6 ページ ２０２０年８月３日 月曜日 午後４時１１分