7
Nomenclature
●
Controller Section
y
ASSIGNABLE CONTROL
You can assign one of the functions of Effect Pa-
rameter Controllers
o
-
@0
to this knob. (
→
page
24)
u
EFFECT BAND 1-8
Switches the corresponding EFFECT BAND 1-8 ON/
OFF and selects an Effect Band for editing.
* To switch the effect ON
→
OFF, hold the button down until
“
oFF
” appears in the display.
* You can also “tap” on the button to set the delay time ac-
cording to the tempo at which the button was tapped. (
→
page 13)
The EFFECT BAND lamps will light in the following
manner to indicate the current condition of the Ef-
fect Band’s settings.
• Lamp lights: Effect is ON
• Lamp off: Effect is OFF
• Lamp flashes (rapidly): Editing
• Lamp flashes (slowly): Input is switched OFF
(
→
page 22)
* When an Effect Band is switched ON, holding the [FUNC-
TION] button and pressing the EFFECT BAND button will
switch the input for that Effect Band ON/OFF. However, when
a group is selected, only the Effect Band that is at the head of
the selected group can be switched ON/OFF.
In the Utility Mode, this button is used to select sys-
tem settings such as Footswitch Functions, MIDI
Functions, etc.
i
EDIT FUNCTION
These buttons are used to set parameters that de-
termine how multiple Effect Bands are connected,
made into groups, synced and for setting the type
of modulation wave, etc.
• CONNECT: Connects Effect Bands
• GROUP: Groups multiple Effect Bands
• SYNC: Synchronizes the modulation speed be-
tween multiple Effect Bands.
• WAVE: Selects the modulation wave to be
used.
• FUNCTION: Provides access to the secondary
functions of those buttons or controllers that
have secondary functions (COPY, PASTE,
PHASE, CONTROL setting, DIRECT PAN).
The lamps indicate current parameter conditions for
the currently selected Effect Band.
Controllers
o
-
!8
listed below are used to
settings for individual parameters for each
of the Effect Bands. Parameter changes will
be made to the Effect Band that is currently
selected with the EFFECT BAND Switch.
Also, when the selected Effect Bands are
combined into a Group, parameters
o
-
!3
will be set in the Effect Band that is at the
head of the selected group.
o
Delay Time Control: Coarse (TIME COARSE)
!0
Delay Time Control: Fine (TIME FINE)
Sets the delay time.
The TIME COARSE knob is used to set the approxi-
mate time while the TIME FINE knob is used to set
the precise time.
!1
LOW CUT FILTER Control
Sets the cut off frequency of the low cut filter. This is
used to cut frequencies that are lower than the cut
off frequency.
When the knob is rotated fully to the left (
oFF
) the
filter is OFF. Rotate the knob to the right to raise the
cut off frequency.
!2
HIGH CUT FILTER Control
Sets the cut off frequency of the high cut filter. This
is used to cut frequencies that are higher than the
cut off frequency.
y
u
i
@1
o
!0
!1
!2
!3
!9
!4
!5
!6
!7
!8
@0
Содержание UD-Stomp
Страница 1: ......
Страница 32: ...Printed in Taiwan V839860 ...