Yamaha TT-R230 2020, Руководство пользователя

Страница: 29 / 80

Operation an d important ri d in g points
6-2
6
EAUW0596
Startin g an d warmin g up a
col d en g ine
In order for the starting circuit cut-off
system to enable starting, one of the
following conditions must be met:

The transmission is in the neutral
position.

The transmission is in gear with
the clutch lever pulled.
See page 4-8 for more informa-
tion.
1. Turn the fuel cock lever to “ON”.
2. Push the ignition switch to set it to
“ON”.
3. Shift the transmission into the
neutral position.
4. Turn the starter (choke) on and
completely close the throttle. (See
page 4-6.)
5. Start the engine by pushing the
start switch.
If the engine fails to start, release
the start switch, wait a few sec-
onds, and then try again. Each
starting attempt should be as
short as possible to preserve the
battery. Do not crank the engine
more than 10 seconds on any one
attempt.
6. After starting the engine, move the
starter (choke) back halfway.
7. When the engine is warm, turn the
starter (choke) off.
TIP
The engine is warm when it responds
normally to the throttle with the starter
(choke) turned off.
NOTICE
ECA11043
For maximum en g ine life, never ac-
celerate har d when the en g ine is
col d !
EAU16641
Startin g a warm en g ine
Follow the same procedure as for
starting a cold engine with the excep-
tion that the starter (choke) is not re-
quired when the engine is warm.
UB6816E0.book Page 2 Thursday, April 2, 2020 9:26 AM