Yamaha SX150C, Руководство по обслуживанию

Страница: 42 / 329

3-9
E
INSP
ADJ
COOLING SYSTEM 3
INSPECTING THE COOLING WATER
DISCHARGE
3
Inspect:
• Cooling water discharge
No discharge
→
Clean and inspect the
cooling water passage.
Inspecting steps
(1) Place the lower unit in water.
(2) Start the engine.
(3) Check that water flows from the cool-
ing water outlet.
3140
OIL INJECTION SYSTEM 3
SYNCHRONIZING THE OIL PUMP 3
1. Inspect:
• Oil pump lever position
Incorrect
→
Adjust.
NOTE:
Make sure the oil pump lever 1 touches the
stopper
a
(fully closed position) when the
throttle valves are closed.
2. Adjust:
• Oil pump lever position
Adjustment steps
(1) Disconnect the oil pump link rod joint
2 .
(2) Fully close the throttle valves.
(3) Turn the oil pump lever
1 so it con-
tacts the stopper
a
(fully closed posi-
tion).
(4) Adjust the position of the oil pump link
rod joint until its hole aligns with the
set pin on the oil pump lever
1 .
(5) Tighten the locknut 3 .
(6) Install the washer and clip.
CAUTION:
After adjustment, make sure the oil pump
lever operates properly.
1
3
2
3160
a
1
3150
COOLING SYSTEM/OIL INJECTION SYSTEM