Yamaha SX150C, Руководство по обслуживанию

Страница: 252 / 329

7-25
E
BRKT
RESERVOIR AND POWER TRIM AND TILT MOTOR
B. If step A was unsuccessful, connect the
leads on the battery terminals and fully
compress the tilt ram assembly by hand.
C. If step B was unsuccessful, loosen the
manual valve, compress the trim and tilt
ram assemblies fully by hand, and then
tighten the manual valve. Then, com-
press and extend the trim and tilt ram
assemblies by connecting the leads on
the battery terminals in the up and down
positions.
D. If step C was unsuccessful, disassemble,
check, and correct any problems with the
power trim and tilt unit.
(3) Connect the leads on the battery termi-
nals in the up position until the trim
and tilt ram assemblies are fully
extended.
7220
(4) Remove the power trim and tilt reser-
voir cap and inspect that fluid is up to
the brim as shown. Add power trim
and tilt fluid if the level is below the
brim.
(5) Repeat the above steps two or three
times until the fluid is at the correct
level.
7230
2. Inspect:
• Power trim and tilt unit operation
Unsmooth operation
→
Bleed the
power trim and tilt unit again.