19
En
Connections
PRE
P
ARA
T
ION
English
■
Connecting the banana plug
(except U.K., Europe, Asia and Korea
models)
1
Tighten the knob using the supplied speaker
terminal wrench.
2
Insert the banana plug connector into the
end of the corresponding terminal.
y
You can also use the banana plug with the SP2 speaker terminals.
Open the tab and then insert one banana plug into the hole on the
terminal. Do not close the tab after connecting the banana plug.
■
Using bi-amplification connections
This unit allows you to make bi-amplification connections
to one speaker system. Check if your speakers support bi-
amplification.
To make the bi-amplification connections, use the FRONT
and SURROUND BACK/BI-AMP terminals as shown
below. To activate the bi-amplification connections, set
“BI-AMP” to “ON” in “ADVANCED SETUP” (see
page 126).
When you make the conventional connection, make sure that the
shorting bars are put into the terminals of the speakers
appropriately. Refer to the instruction manuals of the speakers for
details.
Red: positive (+)
Black: negative (–)
Speaker terminal wrench
Banana plug
Caution
Remove the shorting bars or bridges of your speakers
to separate the LPF (low pass filter) and HPF (high
pass filter) crossovers.
Note
BI-AMP
SURROUND BACK/
FRONT
SINGLE
+
+
+
+
R
L
SURROUND
+
+
R
R
L
L
This unit
Left
Right
Front speakers
