121
En
Advanced setup
AD
V
ANCED
OPERA
T
ION
English
■
Wake on RS-232C access
RS-232C STANDBY
Use this feature to set this unit to transmit data via the RS-
232C interface when this unit is in the standby mode.
Choices: YES, NO
Initial setting:
[U.S.A. and Canada models]: YES
[Other models]: NO
• Select “YES” to set this unit to transmit data via the
RS-232C interface.
• Select “NO” to set this unit not to transmit data via the
RS-232C interface.
■
Remote control AMP ID
RC AMP ID
Use this feature to set the AMP ID of this unit for remote
control recognition.
Choices:
ID1
, ID2
• Select “ID1” when the remote control AMP ID library
code is set to “2001”.
• Select “ID2” when the remote control AMP ID library
code is set to “2002”.
Setting remote control AMP ID code
1
Set the operation mode selector to
C
AMP
or
C
SOURCE
.
2
Press and hold
M
LEARN
for about 3
seconds using a ballpoint pen or similar
object and then press
4
l
/
h
repeatedly
until “L;AMP” appears in the display window
(
B
)
on the remote control.
• Be sure to press and hold
M
LEARN
for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
3
Press
4
ENTER
.
The four-digit code set for the selected input area
appears in the display window (
B
) on the remote
control.
4
Press the numeric buttons (
6
) to enter the
four-digit remote control AMP ID code for the
input area you want to use.
*1 The remote control setting.
*2 The setting of this unit.
5
Press
4
ENTER
to set the number.
“OK” appears in the display window (
B
) if the
setting was successful.
“NG” appears in the display window (
B
) if the
setting was unsuccessful. In this case, start over from
step 2.
6
Press
M
LEARN
again to exit from the setup
mode.
■
Remote control TUNER ID
RC TUNER ID
Use this feature to set the TUNER ID of this unit for
remote control recognition.
Choices:
ID1
, ID2
• Select “ID1” when the remote control TUNER ID
library code is set to “2602”.
• Select “ID2” when the remote control TUNER ID
library code is set to “2603”.
Setting remote control TUNER ID
1
Set the operation mode selector to
D
AMP
or
D
SOURCE
and then press
1
TUNER
on
the remote control to select the tuner to
change the remote control ID.
Notes
LEARN
A/B/C/D/E
PRESET/CH
ENTER
Remote
control AMP
ID code
*1
Function
RC AMP ID
*2
2001
(initial setting)
Operates this unit using the
default code.
ID1
(initial setting)
2002
Operates this unit using an
alternative code.
ID2
A/B/C/D/E
PRESET/CH
ENTER
LEARN