113
En
ADVANCED SETUP
AD
V
ANCED
OPERA
T
ION
English
4
Press the numeric buttons to enter the
four-digit remote control code for the input
area you want to use.
Remote control AMP codes
Select one of the following codes to set the remote control
AMP code for the input area you want to use.
You need to set the corresponding remote control AMP ID
(see page 111).
5
Press ENTER to set the number.
“OK” appears in the display window if setting was
successful.
“NG” appears in the display window if the setting
was unsuccessful. In this case, start over from step 1.
6
Press LEARN again to exit from the setup
mode.
■
Setting remote control tuner ID
1
Set the operation mode selector to AMP or
SOURCE and then press TUNER on the
remote control to select the tuner to change
the remote control ID.
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
the
l
/
h
repeatedly until “L;TUN” and
“TUNER” appear in the display window on
the remote control.
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
3
Press ENTER.
The four-digit code set for the selected input area
appears in the display window on the remote control.
AMP library
code
(remote control
setting)
Function
Remote
control AMP
ID
2001
(initial setting)
To operate this unit using the
default code.
ID1
(initial setting)
2002
To operate this unit using an
alternative code.
ID2
Note
4
3
2
0
9
5
1
7
6
8
STEREO
SUR. DECODE
SELECT
EXTD SUR.
CLASSICAL
LIVE/CLUB
ENTERTAIN
MOVIE
ENTER
A/B/C/D/E
PRESET/CH
LEARN
Notes
TUNER
TV
SOURCE
AMP
TV
SOURCE
AMP
or
LEARN
ENTER
A/B/C/D/E
PRESET/CH
ENTER
A/B/C/D/E
PRESET/CH