Yamaha Rhino 450 YXR45FAV, Руководство по обслуживанию

Страница: 330 / 413

8 - 54
CHAS
STEERING SYSTEM
h. Attach the assembled ball joint remover/
installer, new ball joint B and installer
attachment 8 to the steering knuckle C .
NOTE:
Do not tap or damage the top of the ball joint.
i. Hold the body
3
in place while turning in
the long bolt
4
to install the new ball joint
B
into the steering knuckle
C
.
j. Remove the ball joint remover/installer.
k. Apply lithium-soap base grease to the new
ball joint
B
.
l. Install a new rubber boot and new circlip.
NOTE:
Always use a new ball joint set.
m. Install a steering knuckle oil seal.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
3. Check:
• front wheel bearings
Bearings allow play in the wheel hubs or the
wheel turns roughly
→
Replace.
• oil seals
Damage
→
Replace.
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Clean the outside of the steering knuckle.
b. Remove the oil seals
1
.
c. Drive out the bearings
2
.
WARNING
Eye protection is recommended when
using striking tools.
d. Remove the spacer
3
.
e. Apply lithium base grease to the bearings
and oil seals.
f. Install the spacer to the steering knuckle.
g. Install the new bearings.
NOTE:
Install the outside bearing first.
CAUTION:
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.
2
1
1
3