PJP-EC200 Setup Procedure
7
i.
Talk into the microphone and then record your voice using a sound
recorder on your PC.
ii.
Play back the recording to check its sound quality and volume. If the
sound is distorted (by clip), turn down the microphone volume of your
PC. If the volume is extremely low, turn up the microphone volume of
your PC.
2)
Adjust the microphone level of your PC or webconference system.
i.
Adjust the microphone volume of your PC or webconference system to
keep the volume of the audio delivered to the other end at a moderate
level.
Adjustment
1.
Execute the auto analyzer.
1)
Press AUTO ANALYZER to start the auto analyzer.
2)
Wait until the auto analyzer ends. The shortest distance between the
speakers and microphone is measured and automatically reflected in the
echo canceller settings.
* During the measurement, the microphone picks up test tones output from
the speakers. To achieve the best result, keep the room as quiet as possible
during the measurement.
3)
If you hear the audio guidance “Normally Completed”, the auto analyzer
process (measurement and automatic setup) is properly completed. If you
hear any other guidance, adjust the input gain or other settings by
following the guidance and then perform the procedures 1) and 2) again.
