4 - 96
ENG
MIDDLE GEAR
5.Install:
●
Universal joint
*****************************************************
Installation steps:
●
Install the opposite yoke into the U-joint.
●
Apply wheel bearing grease to the bearings.
●
Install the bearing
1
onto the yoke.
CAUTION:
Check each bearing. The needles can eas-
ily fall out of their races. Slide the yoke
back and forth on the bearings; the yoke
will not go all the way onto a bearing if a
needle is out of place.
●
Press each bearing into the U-joint using a
suitable socket.
NOTE:
The bearing must be inserted far enough into
the U-joint so that the circlip can be installed.
●
Install the circlips
2
into the groove of each
bearing.
*****************************************************
INSTALLING THE MIDDLE DRIVE SHAFT
1.Tighten:
●
Nut (middle drive pinion gear)
1
NOTE:
Secure the middle drive shaft in the vise with a
clean rag.
2.Lock the threads with a drift punch.
New
T
R
.
.
145 Nm (14.5 m • kg, 105 ft • lb)
Содержание GRIZZLY Ultramatic YFM660FP
