Yamaha GRIZZLY Ultramatic YFM660FP, Руководство по обслуживанию

Страница: 304 / 408

8 - 14
CHAS
FRONT AND REAR BRAKES
REPLACING THE REAR BRAKE PAD
NOTE:
It is not necessary to disassemble the brake
caliper and brake hose to replace the brake
pads.
1.Measure:
●
Brake pad wear limit
a
Out of specification
→
Replace the brake
pad as a set.
Brake pad wear limit:
1 mm (0.04 in)
2.Install:
●
Brake pads
●
Brake pad spring
NOTE:
Always install new brake pads, brake pad
shims, insulator and brake pad spring as a set.
*****************************************************
Installation steps:
●
Connect a suitable hose
1
tightly to the
brake caliper bleed screw
2
. Put the other
end of this hose into an open container.
●
Loosen the brake caliper bleed screw and,
using a finger, push the caliper piston into
the brake caliper.
●
Tighten the brake caliper bleed screw.
●
Install new brake pads, new insulator, new
pad shims and a new brake pad spring.
●
Install the retaining bolts and brake caliper.
*****************************************************
T
R
.
.
Brake caliper bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
T
R
.
.
Brake pad holding bolt:
18 Nm (1.8 m • kg, 13 ft • lb)
Brake caliper mounting bolt:
40 Nm (4.0 m • kg, 29 ft • lb)