Yamaha FLIP-X Series, Руководство пользователя

Страница: 45 / 130

Chapter 2 Installation and Connections
2-21
2-4-6 F17/F20
To install the F17/F20 robot, tap holes into the installation base and secure the robot to the base
with M8 bolts from inside of the robot frame.
WARNING
Always turn off the power to the controller before installing the robot. Serious acci-
dents might occur if the robot starts to operate during installation.
●
Installation method
1) Tap M8 holes into the installation base where the robot is to be secured.
For hole pitch, see the external view and dimensions in “5.1 Robot Specifications” of Chapter 5.)
2) Remove the screws securing the upper cover of the robot and remove the upper cover.
If necessary, move the slider to a location where it does not block the installation holes on the
bottom of the robot frame.
3) Secure the robot to the base with the specified bolts and torque.
The bolts and tightening torque are shown below.
Bolt
Tightening torque
Hex socket-head M8 bolt, strength: 8.8T,
length: longer than 45mm (F17), longer than 50mm (F20)
230kg-cm to 370kg-cm
Upper cover
M8 hex wrench