Operation
75
EMU30880
Trolling
EMU41830
Adjusting trolling speed
When the control lever is either in the for-
ward position or in the reverse position and
the throttle is in the fully closed position, you
can randomly adjust the trolling speed be-
tween 650 r/min and 1000 r/min by increas-
ing or decreasing it approximately by 50
r/min. The display will show the engine
speed when the engine speed is increased
from the fully closed position during trolling
speed setting mode. When the throttle is re-
turned to the fully closed position, the display
will show the trolling speed again. When the
engine is turned off or when the engine
speed exceeds 3000 r/min, trolling speed
setting mode will be released.
For details, see the attached operation man-
ual.
TIP:
●
Trolling is affected by currents and other
operating conditions and may differ from
the actual engine speed.
●
When warming up a cold engine, the troll-
ing speed cannot be decreased below the
specified engine idle speed.
EMU27821
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU42190
Procedure for single station and dual
station (main station) models
1. The engine can be turned off either by
pressing the Start/Stop button or by turn-
ing the main switch to the “
” (off) po-
sition. After the engine has been turned
off using the Start/Stop button, turn the
main switch to the “
” (off) position.
ZMU05931
ZMU07256
ZMU06247
ON
OFF
START
6AW-9-77-1E0.book 75 ページ ２０１０年３月１６日 火曜日 午後６時８分
