Operation
53
EMU27671
Warming up engine
EMU27718
Manual start and electric start
models
(1) After starting the engine, allow it to idle
for 3 minutes to warm up.
NOTICE:
Fail-
ure to do so will shorten engine life.
[ECM04550]
(2) Be sure the low oil pressure-alert indica-
tor goes off after starting the engine.
NOTICE:
If the low oil pressure-alert
indicator blinks after the engine
starts, stop the engine. Otherwise,
serious engine damage could occur.
Check the oil level and add engine oil
if necessary. Consult your Yamaha
dealer if the cause for the low oil
pressure alert cannot be found.
[ECM01832]
EMU36532
Checks after engine warm up
EMU36542
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36981
Stop switches
Turn the main switch to “
”, or press the
engine stop button and make sure the en-
gine stops.
Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
with the clip removed from the engine
shut-off switch.
EMU34531
Shifting
EWM00181
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01611
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
(1) Pull the neutral interlock trigger up (if
equipped).
ZMU07918
6C1-9-7J-1E0.book 53 ページ ２０１９年１０月３０日 水曜日 午後２時５６分
