Yamaha F30B 2018, Руководство по обслуживанию

Страница: 291 / 348

9-31
Clamp bracket and swivel bracket
Checking the clamp bracket anode
1. Check:
• Anode
Eroded (1/2 or more)

Replace.
There is grease, oil, or scales.

Clean.
Do not apply grease, oil, or paint to the an-
ode.
Installing the clamp bracket
1. Install:
• Anode
• Tilt support shaft bushing
• Tilt support shaft
• Tilt support knob
• Pin
• Trim sensor (PTT model)
• Swivel bracket bushing
• Clamp bracket (PORT)
• Through tube
• Swivel bracket
• Trim sensor cam (PTT model)
• Clamp bracket (STBD)
• Self-locking nut
• Stopper
• Ground lead
• Clamp (PTT model)
• Grease nipple
• Holder (PTT model)
TIP:
Secure the trim sensor lead “1” using the
clamp “2” and holder “3”.
2. Inject:
• Grease
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Inject grease into the grease nipples until
grease comes out from the bushings “a”.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Adjusting the trim sensor cam
1. Adjust:
• Trim sensor setting resistance
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Fully tilt the swivel bracket down.
b. Loosen the trim sensor cam screw “1”.
c. Measure the trim sensor setting resis-
tance. Adjust if out of specification.
TIP:
• To decrease the resistance, turn the trim sen-
sor cam in direction “a”.
• To increase the resistance, turn the trim sen-
sor cam in direction “b”.
Self-locking nut
22 N·m (2.2 kgf·m, 16 lb·ft)
Grease nipple
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
T
R
.
.
2
3 1 2
1
Digital circuit tester
90890-03243
Digital multimeter
YU-34899-A
a
1
b
d
c
a