1033285C - 2/12
Keep the pads from
curling at the sides
when positioning
the towers.
Pull against the back of
the tower to seat the
tower on the rail.
You may need to
loosen the bolt on
very wide rails.
BEHIND THE TOWER,
position the rail hook into the rail.
DO NOT INSTALL TOWER DIRECTLY
OVER FACTORY CROSSBAR.
You may need to move the factory crossbar if
there is any interference with the towers.
Lift the rubber flap
to see if the rail is seated into the
curve of the tower. There should not
be any gap between the tower and
the rail in the curve.
Hook the rail.
ATTACH TOWERS
TO CROSSBAR.
On a level surface,
insert bar through
tower.
Push end caps onto the
ends of the crossbars.
Be careful to keep the bars
horizontal; the loose towers could slide off the bar.
Loosen the tower
bolts with the
supplied wrench.
Place a set of towers and
bars onto your car’s racks.
POSITION
TOWERS AT
EQUAL
DISTANCE.
You may need to
loosen the bolt on
very wide rails.
