Instruction #1036093B-3/9
NOTE:
Carefully clear away any debris
to prevent scratching your vehicle.
NOTE:
Carefully clear away any debris
to prevent scratching your vehicle.
Move the tracks aside and drill an 1⁄8” pilot hole
through the center of the marks you made
in step 6. Then drill the holes to their final
diameter of 1⁄4”.
TIP:
A center punch can help
you to locate your pilot hole more accurately.
Move the tracks aside and drill an 1⁄8” pilot hole
through the center of the marks you made
in step 7. Then drill the holes to their final
diameter of 1⁄4”.
TIP:
A center punch can help
you to locate your pilot hole more accurately.
8
9
DRILL THE REAR PANEL HOLES.
DRILL THE FRONT PANEL HOLES.
2X
2X
2X
2X
4X
4X
Never
punch
or drill
through
the track!
Never
punch
or drill
through
the track!
10
INSTALL 4 BOLTS, 4 WASHERS, AND 4 CAPNUTS.
Install 1 bolt with 1 washer through each track where you drilled the holes in steps 8 and 9.
Then from inside your cover, attach a cap nut. Do not fully tighten the hardware yet.
