Instruction #1036093B-2/9
3
4
5
2
Set the tracks on your vehicle in the
approximate location that you will install
them. Measure and position the track
ends equally from the front and rear of
the cover being sure to pay attention to
the locations of the crossmembers and
handles you identified in step 1.
Thouroughly clean your Diamondback Cover.
On each side of the rear tracks
(closest to the rear of the truck),
measure and position 2” from the edge
of the bend on the cover as shown.
On each side of the front tracks
(closest to the center of the cover),
measure and position 2” from the edge
of the bend on the cover as shown.
POSITION THE TRACKS FOREWARD AND AFT.
POSITION THE REAR TRACK ENDS.
POSITION THE FRONT TRACK ENDS.
2X
2X
2X
2X
6
7
2X
2X
2X
2X
MARK THE REAR PANEL HOLES.
MARK THE FRONT PANEL HOLES.
Mark the rear-most hole for each
rear track. Use a marker to mark the
location of the holes at the ends of the
track closest to the rear of the vehicle.
Mark the rear-most hole for each front
track. Use a marker to mark the location
of the holes at the ends of the track
closest to the rear of the vehicle.
