Yaesu FTM-400XDR/DE, Руководство по эксплуатации

Страница: 78 / 220

78
Scanning
Signal Search
Memory scan
The FTM-400XDR/DE transceiver will scan the frequencies registered in the memories
in the order of the memory channel number.
1
Switch to the memory mode
2
Press briefly
The function menu will be displayed.
3
Touch [SCAN]
Tip When [SCAN] is not displayed in the function menu,
touch [BACK] or [FWD] to switch the menu.
The scanning will start from the lowest to the highest
memory channel number.
Ჹ ᲼ Ჽ Ჾ Ჸ Ჸ
Ჹ Ჺ ᳀ ; 1 - 1 * # / #
᲼ ᲻ ᲻ ᳀ Ჾ Ჸ
Ჽ Ჸ Ჸ 6 1 - ; 1 Ჺ ᲻
/ 76' 5%12' / 8 5 3 .
5-+25'.
1 ((
& 9
6Z29 4
* +
5 % # 0 4 ' 8
( 9 & $ # % -
During scanning, the decimal point of the frequency
display will blink.
When a signal is received, the scan will stop for three
seconds before starting to scan again.
Tips • The scan can also be started by pressing the [UP] or
[DWN] button on the microphone for one second or
longer.
Ჹ ᲼ Ჽ Ჾ Ჸ Ჸ
Ჹ Ჺ ᳀ ; 1 - 1 * # / #
᲼ ᲻ ᲻ ᳀ Ჾ Ჸ
Ჽ Ჸ Ჸ 6 1 - ; 1 Ჺ ᲻
/ 76' 5%12' / 8 5 3 .
5-+25'.
1 ((
& 9
6Z29 4
* +
4 ' 8
( 9 & $ # % -
5 % # 0
• The scanning direction (UP/DOWN) can be set using [SCAN] → [2 SCAN DIRECTION] in the
set-up menu.
• The action to be taken when scanning is stopped can be set using [SCAN] → [3 SCAN
RESUME] in the set-up menu (refer to the previous page).
• The squelch level may be adjusted using the following procedure during scanning.
Touch [SQL] → Turn
●
To stop the scanning
To stop the scanning, either touch [SCAN] or press the microphone [PTT] button (the
radio will not transmit in this case).